| Last Modified: 11-29-2007 | 1.6 A | |
| Service Category: Drivetrain | Section: Axle/Differential | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM0000016X400NX |
| Title: AXLE AND DIFFERENTIAL: STEERING KNUCKLE: INSTALLATION (2008 Sequoia) | ||
INSTALLATION
HINT:
- Use the same procedure for the LH side and RH side.
- The procedure listed below is for the LH side.
1. INSTALL KNUCKLE GREASE RETAINER CAP LH (for 2WD)
|
(a) Using a brass bar and hammer, tap in a new retainer cap. NOTICE:
|
2. INSTALL STEERING KNUCKLE OIL SEAL LH
|
(a) Using SST and a press, press in a new oil seal. SST: 09950-60020 09951-01030 SST: 09950-70010 09951-07100 NOTICE:
|
3. INSTALL STEERING KNUCKLE LH
(a) Install the front suspension upper arm to the steering knuckle with the nut.
Torque: 110 N·m (1122 kgf·cm, 81 ft·lbf)
(b) Install a new clip.
HINT:
If the holes for the clip are not aligned, tighten the nut up to another 60°.
4. CONNECT FRONT LOWER BALL JOINT ATTACHMENT LH
5. CONNECT TIE ROD END SUB-ASSEMBLY LH
6. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH
(a) Install the front axle hub
.
7. CONNECT FRONT SPEED SENSOR LH
|
(a) Connect the front speed sensor to the steering knuckle with the bolt. Torque: 11 N·m (107 kgf·cm, 8 ft·lbf) |
(b) Attach the clip to the steering knuckle.
8. INSTALL FRONT WHEEL
- for Aluminum Wheel
Torque: 131 N·m (1336 kgf·cm, 97 ft·lbf)
- for Steel Wheel
Torque: 209 N·m (2131 kgf·cm, 154 ft·lbf)
9. CHECK SPEED SENSOR SIGNAL
(a) Check the speed sensor signal
.
10. INSPECT SRS WARNING LIGHT
(a) Check the SRS warning light
.
11. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(a) Inspect and adjust the front wheel alignment
.
|
|